Product ID:POWERCRON YELLOW PASTE, AP266
MSDS Date:10/23/1992
FSC:8010
NIIN:00N039238
MSDS Number: BRJBR

PPG INDUSTRIES INC

4325 ROSANNA DR
ALLISON PARK, PA 15101
US

Emergency Phone: 304-843-1300

Info Phone: 800-441-9695;412-492-5555

Cage: 47695

PPG INDUSTRIES INC

PITTSBURGH, PA 15272 US

Telephone: 1-800-245-2974 (CAL HYPO)

Cage: 47695

& LIVER ASSOC W/ADMIN OF ETHYLENE GLYCOL MONOBUTYL

RTECS: 9999999ZZ

# 90-118) .

RTECS: 9999999ZZ

TYPE OF AIRBORNE CONTAMINANTS AGAINST WHICH

RTECS: 9999999ZZ

LEL BELOW STATED LIM, & TO REMOVE DECOMPOSITION

RTECS: 9999999ZZ

OF BUTYL RUBBER, NEOPRENE RUBBER OR NITRILE

RTECS: 9999999ZZ

PHYS IMMED. HAVE MSDS INFO AVAILABLE.

RTECS: 9999999ZZ

IRON (III) OXIDE

CAS: 1309-37-1

RTECS: NO7400000

Fraction By Weight: 15-20%

OSHA PEL 10 MG/M3 (FE)

ACGIH TLV: 5 MG/M3(FE),B2; 9293

TITANIUM OXIDE; (TITANIUM DIOXIDE)

CAS: 13463-67-7

RTECS: XR2275000

Fraction By Weight: 10-15%

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST; 9293

2-PROPANOL,1,1'-IMINODI-; (DIISOPROPANOLAMINE)

CAS: 110-97-4

RTECS: UB6600000

Fraction By Weight: 2-5%

ETHANOL, 2-BUTOXY-; (ETHYLENE GLYCOL MONOBUTYL ETHER)

CAS: 111-76-2

RTECS: KJ8575000

Fraction By Weight: 20-25%

OSHA PEL S, 50 PPM

ACGIH TLV: S, 25 PPM; 9293

FILM FORMERS, RESINS, & ADDITIVES

Fraction By Weight: 40-45%

DIETHYLENE GLYCOL; (GLYCOL ETHERS)

CAS: 111-46-6

RTECS: ID5950000

Fraction By Weight: 20-25%

INCR RISK OF CANCER FROM EXPOS. POTNTL FOR

RTECS: 9999999ZZ

VERY LIM. SINCE OVEREXP ARE NOT EXPECTED, THERE IS NO

RTECS: 9999999ZZ

GLYCOL ETHER &/OR ACETATE WHICH HAS BEEN SHOWN TO

RTECS: 9999999ZZ

AND/OR BLOOD-FORMING TISSUE. THERE IS NO CONCLUSIVE

RTECS: 9999999ZZ

INDICATIONS THAT SOLV LEVELS ARE TOO HIGH. RED,

RTECS: 9999999ZZ

EYE

RTECS: 9999999ZZ

EXCESS EYE CONT. DRY, ITCH, CRACK, BURN, RED, &

RTECS: 9999999ZZ

STUDIES HAVE CLEARLY DEMONSTRATED DOSE-RELATED

RTECS: 9999999ZZ

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE: INGEST: HARMFUL/FATAL IF
SWALLOWED. EYE: CAUSES SEV IRRIT. SKIN: CAUSES PRIMARY IRRIT. MAY
BE HARMFUL IF ABSORBED THRU SKIN. INHAL: VAP & SPRAY MIST HARMFUL.
VAP GENERATED @ ELEVATED TEMPS IRRI TATE EYES, NOSE & THROAT. RPTD
EXPOS TOHIGH VAP CONC MAY CAUSE IRRIT OF RESP EXPOS & PERM BRAIN &
NERV(EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ: DAM. INTENTIONAL MISUSE BY DELIB CONC
& INHALING CONTENTS CAN BE HARMFUL/FATAL. CHRONIC: AVOID LONG TERM
& RPTD CONT. PROD CNTNS TITANIUM DIOXIDE. ANIMALS INHALING MASSIVE
QTY OF TITANIUM DI OXIDE DUST IN A LONG-TERM STUDY DEVELOPED LUNG
TUMORS. STUDIES W/HUMANS INVOLVED IN MFR OF THIS PIGMENT INDICATE
(ING 7)

First Aid:INGEST:DO NOT INDUCE VOMIT. EYE: FLUSH IMMED W/PLENTY OF
WATER FOR @ LST 15 MIN. SKIN: FLUSH IMMED W/PLENTY OF WATER
FOLLOWED BY WASHING W/SOAP & WATER. INHAL: REMOVE TO FRESH AIR.
APPLY ARTF RESP & O THER SUPPORTIVE MEASURES AS REQD. INGEST: GET
MED ATTN IMMED . OTHER: IF INGEST, ANY TYPE OF OVEREXP/SYMPS OF
OVEREXP OCCUR DURING/FOLLOWING USE OF PROD, CONT A POIS CTL CTR,
EMER ROOM/ (ING 20)

Flash Point Method:PMCC
Flash Point:135F,57C
Lower Limits:1.3%
Extinguishing Media:USE NFPA CLASS B EXTING (CARBON DIOXIDE, DRY
CHEM/UNIVERSAL AQUEOUS FILM FORMING FOAM) DESIGNED TO EXTING NFPA
(SUPDAT)
Fire Fighting Procedures:NIOSH/MSHA APPRVD SCBA & FULL PROT EQUIP.
WATER SPRAY MAY BE INEFTIVE. WATER SPRAY MAY BE USED TO COOL CLSD
CONTRS TO PVNT PRESS BUILD-UP & (SUPP DATA)
Unusual Fire/Explosion Hazard:KEEP CONTRS TIGHTLY CLSD. ISOLATE FROM
HEAT/ELEC EQUIP, SPARKS, & OPEN FLAMES. CLSD CONTRS MAY EXPLODE
WHEN EXPOSED TO EXTREME HEAT. DO NOT APPLY TO (SUPP DATA)

Spill Release Procedures:PROVIDE MAX VENT. ONLY PERS EQUIPPED W/PROPER
RESP & SKIN & EYE PROT SHOULD BE PERMITTED IN AREA. REMOVE ALL
SOURCES OF IGNIT. TAKE UP SPILLED MATL W/SAWDUST, VERMICULITE/OTHER
ABSORB MATL & PLACE INT O CONTRS FOR DISP.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:DO NOT STORE ABOVE 120F. STORE LG QTY
IN BLDGS DESIGNED & PROTECTED FOR STORAGE OF NFPA CLASS II COMBUST
LIQ. CONTRS SHOULD BE GROUNDED WHEN POURING.
Other Precautions:IF MATL IS IS PART OF A MULTIPLE COMPONENT SYSTEM,
READ MATL SAFETY DATA SHEET(S) FOR OTHER COMPONENT OR COMPONENTS
BEFORE BLENDING AS THE RESULTING MIXTURE MAY HAVE HAZ OF ALL OF ITS
PARTS. AVOID FRE E FALL OF LIQ IN EXCESS OF A FEW INCHES.

Respiratory Protection:OVEREXP TO VAPS MAY BE PVNTD BY ENSURING VENT
CTLS, VAP EXHAUST/FRESH AIR ENTRY. NIOSH/MSHA APPRVD (TC-23C) AIR
PURIFYING/AIR SUPPLIED(TC-19C) RESP MAY ALSO REDUCE EXPOS. READ
RESP MFR'S INSTRUCTIONS & LITERATURE CAREFULLY TO DETERM(ING 16)
Ventilation:PROVIDE GEN DILUTION/LOC EXHAUST VENT IN VOL & PATTERN TO
KEEP CONC OF INGRED BELOW LOWEST SUGGESTED EXPOS LIM, (ING 17)
Protective Gloves:IMPERMEABLE GLOVES CONTRUCTED (ING 18)
Eye Protection:CHEM WORK GOG OR FULL LNGTH FSHLD.
Other Protective Equipment:WEAR PROT CLTHG, INCL IMPERMEBALE APRON
CONSTRUCTED OF: BUTYL RUBB, NEOPRENE RUBB/NITRILE RUBBER.
Work Hygienic Practices:CLEAN/DISCARD CONTAMINATED CLOTHING AND SHOES.
Supplemental Safety and Health
EXTING MEDIA: CLASS II COMBUST LIQ FIRES. FIRE FIGHT PROC: POSS
AUTOIGNIT/EXPLO WHEN EXPOSED TO EXTREME HEAT. IF WATER IS USED, FOG
NOZZ ARE PREF. EXPLO HAZ: HOT SURF. TOX GASES MAY FORM WHEN PROD IS
CONTACTED BY FLAME/HOT SURF. HAZ DECOMP: NITROGEN, FORMALDEHYDE.

Boiling Pt:B.P. Text:>192F,>89C
Vapor Pres:7.3
Vapor Density:HVR/AIR
Spec Gravity:1.36
Evaporation Rate & Reference:55(BUTYL ACETATE=1)
Solubility in Water:21.4%
Appearance and Odor:VISCOUS LIQUID W/AN ODOR CHARACTERISTIC OF SOLVENT
INGREDIENTS.
Percent Volatiles by Volume:34.60

Stability Indicator/Materials to Avoid:YES
AVOID CONT W/STRONG ALKALIES, STRONG MINERAL ACIDS, OR STRONG OXIDIZING
AGENTS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:MAY PRDCE HAZ DECOMP WHEN HEATED.
WELD, BRAZ/FLAME-CUTTING MAY PRDCE FUMES INCL: CARBON MONOXIDE,
OXIDES OF (SUPP DATA)

Waste Disposal Methods:WASTE MATERIAL MUST BE DISPOSED OF IN ACCORDANCE
WITH FEDERAL, STATE, PROVINCIAL, AND LOCAL ENVIRONMENTAL CONTROL
REGULATIONS. EMPTY CONTAINERS SHOULD BE RECYCLED OR DISPOSED OF
THROUGH AN APPROVED WA STE MANAGEMENT FACILITY.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.